H065N Cold bend testing machine

This equipment has been studied and designed to perform bending tests on steel bars for reinforced concrete.

The machine can perform two types of test:

• bending the specimen through 180° only with mandrels up to max. 96 mm included.
• bending the specimen through 90° and then straightening it again up to a minimum of 20° only with mandrels over 96 mm diameter.

This bending machine is composed of a rugged frame supporting a beam having a cylinder with relevant load piston fixed on it, being activated by an hydraulic cell complete with speed adjuster for the piston, direction control valve, max. pressure valve, control gauge.
The whole is cased to protect every single component from the dust, and the operator from any possible danger. A small bowl has been fitted under the beam, where the steel bar is bent.
Two contrasting rollers are fitted on the beam. They may easily be adjusted in distance to be in accordance with the Standards concerning bars having diameter between 5 and 40 mm.
Fixing and changing the mandrels on top of the thrust cylinder is easy and practical and grants the operator a perfect interchangeability of the same.

A device prevents the unlocking of the bar under test from the relevant rollers and the contrasting mandrel both during the bending and the staightening operation.
The machine accepts bars up to Ø 40 mm. and is supplied complete with two series of rollers, having respectively Ø mm. 50 and 100. The mandrels, the mandrel-holders and the brackets are not included in the standard supply and have to be ordered separately.

COLD BENDING